DigiPlus stock

Fuel Rail Pressure Sensor is DigiPlus stocka very important component, which is with cars The performance, fuel economy and emission level of the engine are closely related. If it has any failure, it will lead to a decline in engine performance, a decrease in fuel economy, and even serious emission problems. Therefore, it is very important to test the fuel rail pressure sensor in a timely manner. Next, let's learn how to test the fuel rail pressure sensor.Step 1: Check the sensor connection. First, you should check the connection between the fuel rail pressure sensor and the engine cable. If the connection is loose or the cable is broken, it will cause the sensor to fail. Therefore, please make sure that the connection is stable before testing. Step 2: Test the resistance of the sensor. Before testing the fuel rail pressure sensor, check the resistance value of the sensor. Use a multimeter to test the resistance value of the sensor. Before testing, determine the expected resistance range by consulting the technical manual of the vehicle. Set the instrument to resistance measurement mode, and then test the resistance between the two pins of the sensor. If the resistance value is not within the expected range, it means that there is something wrong with the sensor. That is to say, it may not be able to output the correct pressure value under normal operating conditions. Step 3: Checking the sensor line and testing the sensor line is also a very important step.Use a mulometer or a pressure needle to check the sensor circuit. In order to test the line, you need to stop the engine first, and then remove the connection cable from the sensor. After that, set the instrument to voltage measurement mode. Then, the black connection cable of the mulmeter is connected to the engine ground wire at one end, and the red connection cable is connected to the signal pin at the other end. Then restart the vehicle engine to keep it idle. At this time, return to your previous instrument and pay attention to check each continuous voltage reading. If the voltage of the sensor can be continuously stable under different loads (such as vehicle idling and high-speed operation), it indicates that the sensor line should work normally. Step 4: Check the fuel pump relay and test the fuel pump relay is also a necessary step to test the fuel rail pressure sensor. Check whether the fuel pump relay can work normally,In this way, the fuel is delivered to the correct position and pressure, and the sensor can output the correct pressure to the electronic injection system of the car. Remove the connection cable from the engine pressure sensor and combine it with the circuit diagram to ensure that the fuel pump relay can be controlled by multiple relay clusters respectively. If it is determined that there is no problem with the relay, the line of the relay and its associated sensor circuit should work normally. Finally, the test of the fuel rail pressure sensor should be carried out according to the recommendation of the manufacturer's technical manual to ensure that it can always work normally. If you don't know how to test, please seek professional technical support. Correctly understanding and detecting the fuel rail pressure sensor can ensure the fuel economy of the vehicle, reduce emissions and improve engine performance.

Contact Us
Phone：020-83484696